![]() We are at this point only able to connect to the file shares already setup on the NAS. The reason for these error messages is that the software for these servers are requiring something called TLS 1.0, and that browsers have dropped support for these TLS versions.Īs Netgear no longer is releasing firmware upgrades to enable support for TLS 1.2 means that we are not able to login to the admin interface for our Netgear ReadyNAS servers to perform any further configuration or maintenance, etc. You therefore now simply get errormessages and cannot access the admin interface. The admin interface of the server should open up in your browser, and this is where the problem start as the sw on these NAS servers are no longer supported by most browsers. Next, you would click to access the admin interface of the desired NAS server. You would normally launch the RAIDar software, and this will scan your network for available ReadyNAS servers. To access the backend admin interface for these servers you would normally use a SW called RAIDar which can be found on: On the specifications side there are a good few differences between these, but I am not going into those differences here as that is not relevant to this article. In the picture you can see the V1 versions at the bottom in light grey color, while the V2 versions is on top in the darker grey color. Typically the first one (NV+) is the one using the SPARC processor, and the second one (NV+ V2) is the one using the ARM processor. Without going too much into the nitty gritty part of these servers I would personally categorise my ReadyNAS servers as follows: Up until recently Netgear has been providing regular upgrades, but many of these NAS servers have now entered EOL - End Of Life, and Netgear hence does not provide the updates required so that these can be used into the future. The technology has hence been around for quite a while, and as these become older there is also popping up a few hurdles as the technology they depend on is becoming obsolete. The process for performing an OS reinstall reset reboot varies by storage system.As I mentioned in my previous post about the Netgear ReadyNAS servers, I have been using and recommending these servers since 2008. This process reinstalls the firmware on your system and resets the administrator user name and password to factory defaults. If you lost your password but did not enable administrator password recovery, you must perform an OS reinstall reboot to reset the administrator user name and password to factory defaults. Note: This procedure is an option only if you enabled password recovery by providing a password recovery question, answer, and email address as described in the " How do I change the administrator password on my Duo v2 or NV+ v2?" support article. ![]() NETGEAR resets your administrator password and sends an email message with the new password to you. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |